[handicapper]

i replaced part # wb27t10305 (oven control erc111) and i have some wires from the oven that dont seem to have a place to plug into on the new control board 1. no ground tab to plug green wire on to. 2. black wire that plugs into L1A has a hop wire that should got to LB1 no LB1 to plug hop wire on to. 3. purple broil wire now should plug into a little black box but there are 3 tabs i could plug into, there are two horizontal and one vertical tab on the box, which one? same with theyellow bake wire 2 horiz. and on vert. so far all the #'s for part and order and mfg # match up. are some of the wires not needed for new control board? danny

[Simon / APP Team]

Hi.

if you look closely at two black relays you will see that there is only one way the wires can be connected. Unfortunately the picture on the diagram is not large enough to read the markings. Do you think that you can post the clear pictures of the old and new controls?

Simon.

[abadfish66]

I am strictly going off memory here, but I do know the ground wire is not needed, tape the end off the ground wire and forget about it. next the Purple broil wire goes to the black broil relay. If you look closely at the relay there will be a marking that says NO, COM and NC. The purple wire goes to NO, which stands for normally open. same with the bake wire, it goes to the bake relay marked NO. Now, the other wire you have left over, should go to the broil relay marked Com.

[handicapper]

okay, ive recieved the new oven control...g.e. part # wb27t10265, replacing wb27k5273......all wires have a place to go except the black with the hop wire, on the old one it went to L1A and hop to LB1 OR VICE VERSA (PLEASE CLARIFY FOR ME OKAY) the new control has an L1A tab and therre is a L1B but no tab to plug it on to, so im not sure where it should go
thank you ....handicapper.........i checked pictures....black wire goes to LB1 and hops to L1A ...there is a marking that says L1B but no tab and there is a L1A for hop wire to plug on to so the only thing i need to know is what do i do with the wire for L1B?.....thank you

[handicapper]

okay, ive recieved the new oven control...g.e. part # wb27t10265, replacing wb27k5273......all wires have a place to go except the black with the hop wire, on the old one it went to L1A and hop to LB1 OR VICE VERSA (PLEASE CLARIFY FOR ME OKAY) the new control has an L1A tab and therre is a L1B but no tab to plug it on to, so im not sure where it should go
thank you ....handicapper.........i checked pictures....black wire goes to LB1 and hops to L1A ...there is a marking that says L1B but no tab and there is a L1A for hop wire to plug on to so the only thing i need to know is what do i do with the wire for L1B?.....thank you
Last edited by handicapper : Today at 10:13 AM. Reason: more info


Read more: g.e electric 220 single oven
http://forum.appliancepartspros.com

[Simon / APP Team]

Hi.

The L1 Black wire jumper goes to the Broil relay COM.

The green ground wire could be disregarded if you have a plastic control panel. If it's stainless steel attach the ground wire to the one of the control board mounting screws.

Simon.