|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Top Cap For Down Ventsystem |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
06-29-2012, 07:31 AM
|
|||
|
|||
Top Cap For Down Ventsystem
Model Number: JVB67ABB Brand: GE Age: 5 - 10 years
I purchased the 36" trim for my GE down vent system. How do you remove the old part? I have spoke to GE and visited their web site to no avail. I have seen a previous discussion on your forum. Not appliable. On raising the snorkel I have no visable screws or nuts to remove either on top or underneath the existing top cap. My order no. was 2644005.
Thank you Ads By Google Related Models 
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
06-29-2012, 06:33 PM
|
||||
|
||||
|
Hi Bill,
According to the Tech sheet (attached to the post), the top trim is held in place with adhesive. To remove, start at one end and peel the trim off the snorkel. Here are the breakdown diagrams and Replacement parts for General Electric JVB67ABB Electric range | AppliancePartsPros.com Gene.
__________________
Appliance Repair Expert in Orange County, California. Order Appliance Parts with 365-Day Hassle Free Return Policy - AppliancePartsPros.com
|
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
