Oven Repair (including Ranges and Cooktops)

George Karschney · #1 (**permalink**) 03-21-2012, 12:24 PM

Range shows error code F13, nothing works. Turned off circuit breaker and then turned it back on and range works for awhile but will again display same error code and has to be reset. I cannot find anything on error code F13.
Any ideas? Thanks

Joe / APP Team · #2 (**permalink**) 03-21-2012, 03:16 PM

George, The F13 error code indicates an issue in the ERC/Control, "F13 = Bad EEPROM Identiﬁcation/Checksum error. > . (F11, 12 & 13) Disconnect power, wait 30 seconds and reapply power. If fault returns upon power-up, replace EOC." Part number: AP3874704

Thanks and Good Luck

George Karschney · #3 (**permalink**) 03-22-2012, 08:05 AM

I had a hunch that was the problem. Thanks for the confirmation.
George

Joe / APP Team · #4 (**permalink**) 03-22-2012, 08:18 AM

Quote:

Originally Posted by George Karschney

I had a hunch that was the problem. Thanks for the confirmation.
George

George,
You're welcome, it's our pleasure to assist you. Drop us a line anytime.
Good Luck, and Thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Duet error code FH and diagnostic code C03	angelo78	Washer Repair	0	03-21-2012 08:12 AM
f7 error code	Paul T Davidson	Microwave Repair	0	05-17-2011 12:06 PM
LG error code OE - drain error	JPotter	Washer Repair	0	04-01-2011 07:20 AM
frigidaire error code F10 - not listed in your error codes	Skully26	Oven Repair (including Ranges and Cooktops)	2	02-16-2010 04:29 AM
Error code	wilsontwo	Oven Repair (including Ranges and Cooktops)	1	05-31-2009 06:55 AM

Error Code F13

Oven Repair (including Ranges and Cooktops)

Range shows error code F13, nothing works. Turned off circuit breaker and then turned it back on and range works