[Rfosina]

I have a wm27460w Jenn air wall oven. About 2 years ago the panel went out and we would use the oven by simply pressing the buttons and setting the temperature with no issues. Yesterday, the oven stopped heating. About a month ago, broil was flakey now neither broil or bake work. I disconnected the cables from the electronics oven control and the high temp control, reconnected and when I reset the breaker, there was some heat for a little while but probably not hotter than 100 degrees or so. No heat now.

What parts do I need or what should I start with?

Thanks in advance,

Bob

[Rfosina]

I replaced the electronic clock and the thermostat. The LED display works fine now and needed to be replaced anyway. When I try to turn on the oven, I receive a high pitched hum as the oven is trying to heat. No heat at all. LED shows pre-heat 100 degrees but no heat is there. What should my next steps be?

The parts I just replaced were:

[FONT='Arial','sans-serif']Electronic oven control assembly (AP4088560)[/font]
[FONT='Arial','sans-serif']THERMOSTAT (AP4088629)[/font]

Originally Posted by Rfosina

I have a wm27460w Jenn air wall oven. About 2 years ago the panel went out and we would use the oven by simply pressing the buttons and setting the temperature with no issues. Yesterday, the oven stopped heating. About a month ago, broil was flakey now neither broil or bake work. I disconnected the cables from the electronics oven control and the high temp control, reconnected and when I reset the breaker, there was some heat for a little while but probably not hotter than 100 degrees or so. No heat now.

What parts do I need or what should I start with?

Thanks in advance,

Bob