[wraunch]

All, I have a whirlpool double oven that has been giving me trouble. I had a tech come out and look at it and he said he thinks it's the "board". I can use the top smaller oven with no problems, however when I use the lower oven after about 15-20 minutes the oven beeps then turns off due to detecting a "fault". The tech that came out checked all the circuits and said he thinks they are all ok. We unplugged it and let it set for 30 mins and it wouldn't do it again after it "reset". Now it is doing it again and I am ready to just bite the bullet and buy a new control board if that is what you think is most likely the problem.

Thoughts?

[wraunch]

40 views, no help??? Come'on guys. How hard is the control board to install? I went ahead and ordered one, should be here tomorrow.

[ramblinche81]

Originally Posted by wraunch

40 views, no help??? Come'on guys. How hard is the control board to install? I went ahead and ordered one, should be here tomorrow.

Wall oven was easy. Start to finish under one hour.

Freestanding range/oven might be a little tougher to pull out and access the back panel.

make sure to disconnect power supply before opening up the unit.