Rank: Member
Groups: Registered
Joined: 7/12/2008(UTC) Posts: 27
|
1. The original problem start from no heat and no air blow. 2. I found out there is a "Field Service Mode" to diagnose the possible problem. and came up "....blow motor not up to speed..." message. So, I open up the cabinet, remove the blower motor and check the motor. Found out the motor is OK. 3. Put everything back than power on and go through the boot up sequence. And all system OK, ready to run. 4. But still not get hot air every load. Some times get same "...blow mortor not up to speed.." message from field service mode or machine OK message. 5. I have to go through "boot up" sequence to get my dryer work by luck. 6. What's the proper step I should take next?
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close