Rank: Member
Groups: Registered
Joined: 6/22/2009(UTC) Posts: 2
|
I am replacing the clock circuit board #7601P177-60. There are 6 or 7 knobs that push to cancel functions; I cannot get them off. The adjust knob poled rigth off. Please help don't want to break glass front panel.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 5/31/2009(UTC) Posts: 647
|
LINK > CWE9000ACB Clock ButtonThe following was previously written about a similar clock button setup. It would likely apply to yours as well. kayakcrzy wrote:
What you do is get your two index fingers and put them on the back side of the fat part of the button and pull it right out. They won't break, I have never broke one. Then just push them back in on the new one. They will snap right in. Tom
JFYI Dan O. www.Appliance411.com The Appliance Information Site=D~~~~~~
|
|
|
|
Rank: Member
Groups: Registered
Joined: 6/22/2009(UTC) Posts: 2
|
Thanks Dan, I will try it tonight.
Tom R.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close