|
|||
![]() |
Register | FAQ's | New Posts | Today's Posts | Extras |
» replaced control panel & micrcomputer |
![]() ![]() |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||
![]() Model Number: kesc307hbs6 Brand: Kitchen Aid Age: 5 - 10 years
![]() control panel will not power up. Related Models |
![]() |
See inside of your appliance - diagrams and part photos for virtually every model.![]() powered by AppliancePartsPros.com |
|
||||
![]() Make sure you have 220-240 volts going to the range. Next I would check the screws that connect the power cord to the range to make sure they are tight.
If you don't find the problem there then I would simply trace it back with my volt meter to see why I was not getting power to the control panel.
__________________
ApplianceJunk.com ~ DIY Appliance Repair Forum |
![]() |
See inside of your appliance - diagrams and part photos for virtually every model.![]() powered by AppliancePartsPros.com |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to tell if Oven Control Panel needs to be replaced? | PMS | Oven Repair (including Ranges and Cooktops) | 0 | 01-08-2011 10:31 AM |
Whirlpool Qt Prtnr II, Replaced Htg Element Does the Control Panel Nd 2 B Replaced? | DirtyDishes4Five | Dishwasher Repair | 1 | 10-26-2010 02:14 AM |
Control panel replaced but still getting F2:E0 | NCarper254 | Oven Repair (including Ranges and Cooktops) | 0 | 12-27-2009 01:02 PM |
Replaced control panel still have same problem | bertacini | Oven Repair (including Ranges and Cooktops) | 1 | 11-10-2009 12:25 PM |
Replaced Control Panel, still no input signal | rlegris | Dryer Repair | 10 | 07-12-2008 10:18 AM |