Oven Repair (including Ranges and Cooktops)

mjh1234 · #1 (**permalink**) 11-30-2011, 07:20 AM

new control board installed before thanksgiving. cooked all day. used self clean that evening next morning , no bake no broil

denman · #2 (**permalink**) 11-30-2011, 12:04 PM

Here are your parts
Replacement parts for GFE461LVS models | AppliancePartsPros.com

See the attachment for the tech sheet.

I am assuming that the stove top elements work OK.
Could be that the thermal fuse (Item 26 in Section 3) has blown.
Unplug the unit and ones side of the fuse and measure across it with a meter. It should be 0 ohms.

You may also want to check the oven sensor which could be the cause of the fuse blowing.
Below is a good link on how to do this, check out 7, 8, 20 and 21.
http://www.applianceaid.com/elecrange.html

Note: If you used an extra long self-clean cycle it may have just blown on it's own.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bake and broil elements not cycling in Bake	Dante_M	Oven Repair (including Ranges and Cooktops)	4	04-12-2011 08:04 PM
Kenmore-no bake, no broil after new control board	dennis728	Oven Repair (including Ranges and Cooktops)	0	03-29-2010 04:27 PM
Oven bake/broil not working after bake element replacement	J Justin	Oven Repair (including Ranges and Cooktops)	1	11-05-2009 04:36 PM
Replaced bake element, now won't bake/broil	mvwa	Oven Repair (including Ranges and Cooktops)	0	10-18-2009 12:55 PM
broil no bake	tag	Oven Repair (including Ranges and Cooktops)	2	12-20-2008 03:52 PM

no bake or broil- new control board

Oven Repair (including Ranges and Cooktops)

new control board installed before thanksgiving. cooked all day. used self clean that evening next morning , no bake no