Oven Repair (including Ranges and Cooktops)

Guffey · #1 (**permalink**) 12-09-2008, 09:13 AM

I have an older GE electric JSP26GN range. The oven will not heat up. When I set a bake temperature the indicator changes to 100 degrees for about a minute and then just goes off. The same thing happens with turning on the broiler. I have played with the it a few times and have actually gotten it to start heating so I know the elements are still working but it will not stay on. From what I have found on the internet it looks like I need to replace either the Control panel, the Relay circuit board or the Oven Clock but I do not know which one, and since replacing all three is about the same price as a new range I would like some advice on which is the likely problem. The clock and all the burners are working.

Thanks.

abadfish66 · #2 (**permalink**) 12-09-2008, 09:19 AM

The first thing I would check is the oven sensor, it should read about 1080 ohms at room temp, a bad sensor will cause those symptoms.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
control panel or board????	junebugtraveler	Dishwasher Repair	2	08-28-2008 05:12 PM
Clock on Control Panel Intermittently Fails	MadamWong	Oven Repair (including Ranges and Cooktops)	0	04-25-2008 03:03 PM
Relay verses Switch Control Panel	Boater	Oven Repair (including Ranges and Cooktops)	2	03-05-2008 09:34 AM
wiring diagram for clock/control board	Aaron Richardson	Oven Repair (including Ranges and Cooktops)	0	02-08-2008 11:26 AM
Stove: Control Panel aka. Clock Assembly	hog116	Oven Repair (including Ranges and Cooktops)	0	12-03-2007 08:33 AM

Control Panel, Relay Board or Clock Timer?

Oven Repair (including Ranges and Cooktops)

I have an older GE electric JSP26GN range. The oven will not heat up. When I set a bake temperature