Oven Repair (including Ranges and Cooktops)

jrob · #1 (**permalink**) 10-10-2007, 07:03 AM

just replaced the oven control module still getting error code PF I have the 240v
to the board the question i have, would the keyboard(touch panel) cause this problem, it is attached to module through a membrane connector is there a way to test these switches?

Pegi · #2 (**permalink**) 10-10-2007, 02:49 PM

Sounds like you are getting "noise interference", there are several service pointers addressing this problem but none with model numbers that match yours, might call Whirlpool with your model and serial to see if they know which kit may be available for your unit...

jrob · #3 (**permalink**) 10-11-2007, 05:56 AM

sounds like your saying keypad is not the problem customer says when power outage occurs stove always came back with PF when power restored, until he pushed the cancel button so i take it the keypad OR membrane if defective we would be getting this PF and cannot clear it

richappy · #4 (**permalink**) 10-12-2007, 02:37 AM

Remove keypad ribbon cable and turn power on, if now no problem, replace keypad.
Click on your model # to get it.

jrob · #5 (**permalink**) 10-12-2007, 07:10 AM

yes but with membrane unplug i get the E1 F2 Error code which means keytail unpluged but before that, PF is there for a few seconds so how do you figure that out?

richappy · #6 (**permalink**) 10-12-2007, 06:29 PM

All the symptoms show a stuck keypad. I would replace it.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wall oven bake element not working! Broil works, clock works.	ajachyra	Oven Repair (including Ranges and Cooktops)	1	12-02-2009 06:30 AM
Maytag Oven clock and controls intermittently working	wildbio1	Oven Repair (including Ranges and Cooktops)	1	01-29-2009 10:09 AM
Some oven Digital Controls dont work, stove works fine	tomsoven08	Oven Repair (including Ranges and Cooktops)	2	05-15-2008 09:43 PM
Clock dead, no oven controls, burners barely glow	flower2564	Oven Repair (including Ranges and Cooktops)	1	10-02-2007 04:18 AM
stove top works/clock on/oven controls dead	jrob	Oven Repair (including Ranges and Cooktops)	4	09-20-2007 09:31 AM

stove top works/clock on/oven controls dead

Oven Repair (including Ranges and Cooktops)

just replaced the oven control module still getting error code PF I have the 240v to the board the question