Customer Support 7 days a week

Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

New Topic Post Reply
Options
Go to last post Go to first unread
Deano1  
#1 Posted : Monday, November 10, 2008 8:58:44 AM(UTC)
Quote
Deano1

Rank: Member

Groups: Registered
Joined: 11/10/2008(UTC)
Posts: 4

I have a problem with the oven control. The lock light for the door indicating that it is the self clean mode flashes off and on also the oven door locks randomly. All other oven controls won't work, the range top will function.
The oven hasn't been in the self clean mode for about two weeks. We used the oven since and it worked fine. The oven being to hot is not an issue as it is at ambient temp. When the oven temp sensor is disconnected the oven door locks and won't unlock randomly as when it is connected. Did an ohm check on the oven temp. sensor and it shows continuity.:confused:



Any ideas
Deano
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
abadfish66  
#2 Posted : Monday, November 10, 2008 9:04:51 AM(UTC)
Quote
abadfish66

Rank: Advanced Member

Groups: Senior Expert
Joined: 5/28/2008(UTC)
Posts: 1,620

Most likely problem is the door lock motor, part# WB15T10125
Deano1  
#3 Posted : Monday, November 10, 2008 9:28:51 AM(UTC)
Quote
Deano1

Rank: Member

Groups: Registered
Joined: 11/10/2008(UTC)
Posts: 4

Door lock motor is located where? Do you have how to replace steps?



Deano:)
abadfish66  
#4 Posted : Monday, November 10, 2008 9:44:18 AM(UTC)
Quote
abadfish66

Rank: Advanced Member

Groups: Senior Expert
Joined: 5/28/2008(UTC)
Posts: 1,620

It's located under the cooktop. open oven door, and look under the front lip of the cooktop, there are 2 screws. Take them out and lift up on the cooktop and you'll see it.
Deano1  
#5 Posted : Monday, November 10, 2008 11:37:21 AM(UTC)
Quote
Deano1

Rank: Member

Groups: Registered
Joined: 11/10/2008(UTC)
Posts: 4

I found the motor it appears to we working but never stops, continues to go around and around.
Deano1  
#6 Posted : Monday, November 10, 2008 11:54:41 AM(UTC)
Quote
Deano1

Rank: Member

Groups: Registered
Joined: 11/10/2008(UTC)
Posts: 4

Located the door lock motor it appears to be working but never stops continues to rotate.
abadfish66  
#7 Posted : Monday, November 10, 2008 12:02:48 PM(UTC)
Quote
abadfish66

Rank: Advanced Member

Groups: Senior Expert
Joined: 5/28/2008(UTC)
Posts: 1,620

One of those switches on the assembly is most likely bad. The motor turns when you program to self clean and activates the switch to tell the board the door is locked. When clean is done the motor turns and hits the other switch to tell the board the door is unlocked.
Quick Reply Show Quick Reply
Users browsing this topic
New Topic Post Reply
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.