Oven Repair (including Ranges and Cooktops)

ddlong · #1 (**permalink**) 09-13-2010, 10:32 AM

When finished using oven and the timer, a short while later the"beeping starts" and I get fault F 10. What is causing this? What part is needed? I tried turning off the breaker for awhile and even pushed "reset" but problem still exists.

Joe / APP Team · #2 (**permalink**) 09-13-2010, 01:44 PM

Quote:

Originally Posted by ddlong

When finished using oven and the timer, a short while later the"beeping starts" and I get fault F 10. What is causing this? What part is needed? I tried turning off the breaker for awhile and even pushed "reset" but problem still exists.

DD,

The F10 code on your unit indicates a bad oven temperature sensor.

Part number: AP3969435

Did this start occurring after a self clean cycle ?

Did you notice if you had any overheating, cooking problems ?

have you got tools and a meter to access and check the resistance of the temp. probe ?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
f7 fault code from GE gas range	covi234	Oven Repair (including Ranges and Cooktops)	0	05-21-2010 07:09 AM
Fault code 7, JEN AIR Gas-Elec Range	Bigdigg	Oven Repair (including Ranges and Cooktops)	7	03-13-2010 02:54 PM
Jennair Range Top Fault Code	pheyden	Oven Repair (including Ranges and Cooktops)	1	09-16-2009 03:11 AM
F1 Fault on Kemore Elcectric Range	bodita	Oven Repair (including Ranges and Cooktops)	0	04-28-2009 02:17 PM
Range Fault	RAMREDS	Oven Repair (including Ranges and Cooktops)	1	10-23-2008 12:18 PM

gas range fault F 10

Oven Repair (including Ranges and Cooktops)

When finished using oven and the timer, a short while later the"beeping starts" and I get fault F 10 .

gas range fault F 10

Oven Repair (including Ranges and Cooktops)

When finished using oven and the timer, a short while later the&quot;beeping starts&quot; and I get fault F 10 .

When finished using oven and the timer, a short while later the"beeping starts" and I get fault F 10 .