Microwave Repair

cblack · #1 (**permalink**) 07-03-2008, 11:55 AM

I have the push button used to open the door broken again. It sounds like a spring popped off when trying to open. I have had this repaired twice already. Is this something I can repair myself? The last time it was serviced, the spring had only popped off. I am trying to find a diagram so I can access and repair, any ideas? Whirlpool GT4175SPS-2. Thanks

FaisalAli · #2 (**permalink**) 11-06-2009, 10:48 AM

Yes, here is a link to all the parts and diagrams:
Replacement parts for WHIRLPOOL GT4175SPS2 | AppliancePartsPros.com

BTW, I have a GT4175SPS-0 and I have the same problem. I am also trying to figure out how to open the unit to get to this spring that might have popped. Did you ever figure this out? Also, how much did it cost to repair the MW door and who did you contact?

thanks,
-Al

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sharp countertop microwave open door button broken	ldc	Microwave Repair	0	05-29-2008 01:07 PM
Whirlpool Quiet Partner II have to push in on door to continue cycle	therock297	Dishwasher Repair	0	05-07-2008 07:38 PM
remove broken button	jerry JARMAN	General Talk	1	04-08-2008 06:47 PM
Stops when push to start button is released	Burgbrd	Dryer Repair	4	01-02-2008 08:48 PM
Door latch broken/Door locked	kitade	Dishwasher Repair	2	10-23-2007 11:42 AM

Push button for Door broken (again)

Microwave Repair

I have the push button used to open the door broken again. It sounds like a spring popped off when