[cflamas]

I replaced the Control Panel Asy. (Part# W10210864) and Microcomputer (Part# W10211457) to repair my microwave's F6 error Code and still get an F6 Code. My problem started when I noticed the Control Panel's outer box was not aligned with the oven's door (It was slightly higher). I tried to push it down and it wouldn't bulge, so I placed a board on its upper edge and tried to move it down by hammering the piece. When I connected the oven it read F6-
Call for Service. After I replaced the two parts noted above, I connected the oven and the screen said to program the clock. I set the clock, closed the oven's door and the screen once again read F6. Any ideas or comments? Yes, I know, I shouldn't use a hammer to fix a microwave.