GE Profile MW heating some but not enough
I checked all the door micro switches and they are good based on tech sheet info. Power level is set to P-10. Magnetron leds test correct at no resistence between them either way and infinity resistence leds to case. Rectifier I'm not sure of testing. It being a HV type I am under the impression one will read infinity resistence either way. Does someone have an idea of approach. I did a temp reading of the case of the magnetron using a IR lazer thermo while I tried to heat a bag of popcorn. I got a reading of avaerage 190 degrees F. Bag got warm enough to melt the cooking oil in it but no pop after 5 minutes (should be totally cooked by that time). Water heating test is same result; that is warm to hot but not scortching after 5 minutes. Ideas anyone? I appreciate any input.
Ads By Google