|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Removing GE Profile over-the-range microwave |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
12-19-2007, 06:12 PM
|
|||
|
|||
Removing GE Profile over-the-range microwave
Model Number: JVM132K003 Brand: GE Age: More than 10 years
I'm having the cabinets refinished and want to remove the microwave before they start. This one is vented to an outside duct. I see 2 screws on either side of the unit (at the bottom) which look like they will let the unit slide out of its "receiver bracket" Then there are three screws in the cabinet above that look like they support a lot of weight. Appreciate any advice, warnings!
    
|
|
12-20-2007, 08:37 AM
|
|||
|
|||
|
two people would be a preferrable scenario... more than likely just those three screws on top should be holding it in and the microwave will be resting on a lip on the bottom of the bracket on back wall.. lift up and out while tilting top forward and pull cord through..
__________________
regards jim
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GE Profile convection/microwave | ukusaok1 | Microwave Repair | 2 | 12-21-2007 01:29 PM |
| Removing Microwave from Oven Combo | diyall | Microwave Repair | 0 | 12-09-2007 08:22 AM |
| Removing microwave | dannn | Microwave Repair | 1 | 11-03-2007 02:36 PM |
| GE/Advantium 1.2 Cu. Ft. Over The Range Microwave | DebnJim | Microwave Repair | 2 | 09-13-2007 06:55 PM |
| GE Profile Cas range | PJCIII | Oven Repair (including Ranges and Cooktops) | 3 | 08-27-2007 10:19 AM |
Linear Mode
