Rank: Member
Groups: Registered
Joined: 10/10/2011(UTC) Posts: 6
|
My GE microwave (model JES145DNWW) stopped heating. Everything else seems to work. I pulled the cover and found a melted connector that is plugged into the circuit board where the main power cord hooks up to. I cut the wires from the melted connector and put new stacon terminal on them. It still didn't work. There is a in depth trouble shooting guide inside the microwave but I'm not too sure about the hazards of working on it with the cover off. Is this a problem? And also if you could give me some idea what to check out it would greatly help me, since some of the symbols on the diagram are not too clear. I am an electrician, so I am familiar with how to use a meter, ohm for continuity, and read schemactics fairly good. Thanks for any help you can give me.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close