 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » woodchuckie |
| View Profile: woodchuckie | |||||
|
|||||
Amana top freezer how do you get to the drain tubeThe drain should be located below the evaporator coils on the lower back inside the freezer behind the rear panel. Post your model number and you may can see a diagram. |
|
Frigidaire side-by-side --- no ice, no water Sounds like a water supply problem. Make sure the mesh screen on the water inlet valve is not stopped up and that you have water getting to the valve. You can test the water inlet valve with an ohm... |
|
Ice maker trying to work but no water Is there water or ice in the ice mold? If not put water in it and see if it dumps the ice after it’s frozen. If there is ice, lift the cut off arm and let it drop to see if it will start. If it does... |
|
GE Profile frig leaking water under freezer side You can see the drain pan underneath the fridge behind the kick panel would be the easiest way. But yes it is big enough to hold more than that amount. It is evaporated into the air by the heat... |
|
defrost testing You can turn the defrost timer till it clicks and everything shuts down. The heater should now come on. If it does, replace the timer. If it doesn't, check the heater and defrost thermostat. Turn the... |
|
GE Profile Defrost Heating Coil Failure? check defrost timer, defrost heater, defrost thermostat. Refrigerator Repair Guide: How To Fix a Refrigerator - ACME HOW TO.com... |
|
Ice maker stopped working Try swapping the wires on the dual water inlet valve. Then try the water dispenser. The water should go to the ice maker. This will tell you weather or not the ice maker valve is working and if the... |
| Forum Info | Contact Info | |||||||
|
Join Date: 03-10-2009
Referrals: 0
|
|
|||||||
| Additional Information | Group Memberships | |||||||
|
|
