Kitchenaid DW problem with cycles
Gene,
The final chapter: It was dead because the thermal fuse finally gave out. Replaced it this morning and cycled through a full clean cycle. I give you a high five for the console - wish I had...
|
Kitchenaid DW problem with cycles - Now, no lights at all
I ordered and received the panel, but did not have time to install yet (fortunately). There are now NO lights on panel, when any key is pressed. I have to get a new meter to test for ac at door...
|
Kitchenaid DW problem with cycles - More info
Thanks for the help. Just wanted to update the "ghost" actions. DW will run through wash cycle, then revert to blinking NORMAL - as I noted before. BUT, there is a new twist. If I open the Door after...
|
|
|
Kitchenaid DW problem with cycles - Correction
Dishwasher DOES NOT run full cycle - It will only wash and when done, the normal light blinks. Have to turn off the breaker, wait a few minutes, turn it back on, select Rinse and Start. Not a very...
|
Kitchenaid DW problem with cycles - Kitchenaid DW problem with cycles
Following power drop outs, Normal light blinking and attempted reset by turning off AC to DW. From threads on site, appeared to be issue with control board. Ordered from AppPartsPros and installed....
|
All times are GMT -7. The time now is 01:14 AM.
The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc.
