| Register | FAQ's | New Posts | Today's Posts | Extras |
| » wendlynb |
| View Profile: wendlynb | |||||
|
|||||
| Signature |
| [CENTER][I][FONT=Comic Sans MS]Wen~[/FONT][/I][/CENTER] [CENTER][I][FONT=Comic Sans MS]A little knowledge is dangerous and I know just that much.[/FONT][/I][/CENTER] [CENTER][FONT=Comic Sans MS][COLOR=darkorchid][I]I can do all things through Christ who gives me strength. [/I]Philippians 4:13[/COLOR][/FONT][/CENTER] [CENTER][I][FONT=Comic Sans MS][SIZE=1]Even fix my dryer |
|
I dont know that they can be adjusted, we always replaced the springs and adjusted the overall balance with the legs. When the springs have proper tention then just attaching them to the holes in... |
|
How difficult is it to change out the door gasket on my washer. I noticed a little bit of water on the floor intermitantly and then found a 1 /12 inch slice in the door gasket. |
|
If the washer is level and springs are properly adjusted then it could need a balance ring. Just a thought. |
|
I believe they are all direct drive at least all of the ones we delt with in the past 10 years or so were and we only used whirlpool (domestic) and maytag (commercial). Ya know the motor can hum and... |
|
I know you said the dryer heats but will it dry? We use to see this problm a lot with venting that was obstructed. It was so bad moisture from no ventilation would cause an overheat and the breaker... |
|
I see lots of views on your ? but no replies. That seems odd. I am not a tech but I do know that Whirlpools thin twins could be taken apart as our shop techs used to take them apart often and when... |
| Forum Info | Contact Info | |||||
|
Join Date: 07-31-2008
Referrals: 0
|
|
|||||
| Additional Information | Group Memberships | |||||
|
|