Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » venicebeachvillas

View Profile: venicebeachvillas
venicebeachvillas is on a distinguished road
venicebeachvillas venicebeachvillas is offline
Member
 
Last Activity: 10-14-2013 08:12 AM 

GE Dryer - Confirm diagnosis for system shutting off
Since no one has replied, I went ahead and replaced the motor. The problem still exists, only it shuts down immediately cold or hot every time.

Any idea's ???????????????????????????
GE Dryer - Confirm diagnosis for system shutting off - GE Dryer - Confirm diagnosis for system shutting off
This coin operated dryer shuts off in about 10-20 seconds after a cool start. Once it shuts down it will initially start but shuts back down. If you wait a minute or two it then runs for 10-20...
GE Profile topload washer, no water - GE Dryer - Confirm diagnosis for system shutting off
Hi Vince,

I have that 9350 model. Can you e-mail that manual the you mentioned to kevin_klasing@yahoo.com ?

Thanks
GE Coin Gas Dryer - No Heat - GE Coin Gas Dryer - No Heat
This Gas Dryer heat is not kicking on. I read some other posts but not specific to this dryer. I will try some generic ohm readings on parts.

I can not find the Thermal fuse on the parts list,...
GE Freezer compartment not getting cold enough - Reply to Appliance Junk with frost pattern picture
Hi,

Attached is a picture of the Frost pattern, The frost is in the front to the right on only 1/2 to 2/3's of one of two coils. No frost on the back coil. This could be one of the problems you...
GE Freezer compartment not getting cold enough - Next Step
Thanks for your reply Appliance Junk.

I checked the frost pattern. It is on the right 1/2 of the front coil. No frost on the back coil. Based on this information, do you have any...
GE Profile Dryer Squeak - Fixed
:)
All fixed. The rollers were the cause of the squeak. I ordered new rollers, installed them and the squeak went away.

Thanks for the reply.
Forum Info Contact Info
Join Date: 02-13-2010
Posts
Total Posts: 32 (0.02 posts per day)
Last Post:
GE Profile Dryer Squeak
12-11-2011 03:20 PM
Find all posts by venicebeachvillas
Find all threads started by venicebeachvillas
Referrals: 0
venicebeachvillas has no contact information.
Additional Information Group Memberships
N/A
venicebeachvillas is not a member of any public groups


All times are GMT -7. The time now is 08:46 AM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17