Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » Turbobob

View Profile: Turbobob
Turbobob is on a distinguished road
Turbobob Turbobob is offline
Junior Member
 
Last Activity: 12-08-2013 07:24 PM 

Intermittent ratcheting type of noise from impeller/agitator area - Problem resolved. Loose pulley wheel.
:D Problem resolved. Loose pulley wheel.

I posted this same issue on another repair forum, and received a few suggestions. Here are the results.

It turned out to be a loose pulley wheel rubbing...
Intermittent ratcheting type of noise from impeller/agitator area - Intermittent ratcheting type of noise from impeller/agitator area
Whirlpool Cabrio vertical modular washer, top loader, Model WTW5600XW with impeller.

Only during the WASH cycle, when the low water impeller is operational, I intermittently hear what sounds like a...
Kenmore Range oven handle comes loose, Model 790.94452700 - Kenmore Range oven handle comes loose, Model 790.94452700
The handle on the oven of my Kenmore 790.94452700 (made by Frigidaire) comes loose every month or so after tightening it. The screw on the left side loosens up, while the right side screw is fine.
I...
Erratic display times, won't drain water, won't spin properly - Kenmore Range oven handle comes loose, Model 790.94452700
After more diagnosis, I ordered and replaced the Actuator/Shifter, and this resolved the issue for me. It seems the actuator/shifter was not always moving the tub to the proper position, thus...
Lid Lock light flashes during spin cycle - Lid Lock light flashes during spin cycle
The spin cycle begins OK, but sometimes hear a rapid clicking noise for a few seconds, then continues into spinning. After a few minutes, the Lid Lock light starts to flash, then eventually goes out...
Erratic display times, won't drain water, won't spin properly - Lid Lock light flashes during spin cycle
Yes, I am using HE detergent for cold water. Tried the drain/spin mode, and it filled the tub while in that drain/spin mode. It is as if the processor got hung up and could not reset itself, and...
Erratic display times, won't drain water, won't spin properly - Erratic display times, won't drain water, won't spin properly
Washer goes through the cycles properly, but the displayed times will increase or decrease, then go to the next cycle and do the same thing. Water stays in the tub and during the spin cycle, does not...
Forum Info Contact Info
Join Date: 11-27-2012
Posts
Total Posts: 7 (0.00 posts per day)
Last Post:
Erratic display times, won't drain water, won't spin properly
11-27-2012 09:11 PM
Find all posts by Turbobob
Find all threads started by Turbobob
Referrals: 0
Turbobob has no contact information.
Additional Information Group Memberships
N/A
Turbobob is not a member of any public groups


All times are GMT -7. The time now is 05:55 PM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17