 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » thorning |
| View Profile: thorning | |||||
|
|||||
Maytag Atlantis slow leak into tubI have an Atlantis model MAVT634AWW with s/n 24538149EN that has a slow dribble of water into the tub all the time on the cold side of the supply . If I switch the hoses and use the hot side only it... |
|
Maytag Dyer Flame Does Not Stay Lit I also noted the blower wheel on a Maytag dryer that was freewheeling on the shaft . The problem was the small amount of material in the collar design allows it to eventually wallow out and it will... |
|
Plastic lid in lint trap It may not work but if you have a good vacuum cleaner with a hose attachment try using a flexible plastic tube secured VERY strongly to the end of the vacuum tube. Use duct tape to make sure no... |
|
Maytag Neptune load unbalance We also have a Neptune top load model washer and so far in all the time we have had it not a sngle problem. It is about 7 years old and we run about 7 or 8 loads a week. As others have mentioned it... |
|
Maytag 4000 makes horrendous noise I am considering taking on the repair of a Maytag 4000 series washer only a few years old that has a failed bearing. The owner says the bearing has failed twice before in the last 2 years. Before I... |
|
Maytag washer loud spin cycle I have the opportunity to pick up a Maytag series 4000 front load washer in nice condition that is only about 2 years old for almost no cost. It has a bad bearing and sounds like a freight train when... |
|
Maytag Neptune load unbalance I just posted a message about a product called Oil of Wintergreen you may want to try . |
| Forum Info | Contact Info | |
|
Join Date: 08-25-2012
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
