Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » ThatGuy

View Profile: ThatGuy
APP Volunteer
ThatGuy is on a distinguished road
ThatGuy ThatGuy is offline
ThatGuy's Avatar
Last Activity: Today 07:05 PM 

KENMORE ELITE: Hums and inside heats up when closing the door.
I'd bet you have a stuck relay (the contacts inside are welded together)

There are two relays that handle high amp draw on this board. One or both are damaged. You would need to check them with a...
Air Duct
Why are you replacing this part? How did it fail?

You should be able to remove the rear panel and a few screws on the inside of the drum to get it off according to this picture.

Parts for...
Neverending story [ getting old]
275 is way too hot. It shouldn't get above 175 F.

A wiring diagram would be helpful, but I think its your control board. I think the relay is welding its contacts together and heating all the...
whirlpool GEX9868jt2. Was getting E1 error. replaced thermistor. Still getti
Drying is a combination of heat and airflow.

Check your vent and make sure its clean and unrestricted all the way to the outside. Check inside the lint filter area too.

I also found this on another...
Maytag dryer won't start
The wiring diagram shows two thermal fuses. Always remove one wire when you test for continuity.

Parts for Maytag LDE8604ACE: Wiring Information-LDE8604ACX Parts -
Kenmore Dryer Wont Turn On
I suspect the dryer motor start switch is stuck in the "run" position. It could just need a real good cleaning or it could be bad.

This video might help.
Refrig cooling issues
Could you post a picture or vid of your compressor area and fan?

Are you running it with the back cover in place?
Forum Info Contact Info
Join Date: 07-27-2010
Total Posts: 1,080 (0.40 posts per day)
Last Post:
Refrig cooling issues
11-11-2017 02:50 PM
Find all posts by ThatGuy
Find all threads started by ThatGuy
Referrals: 0
ThatGuy has no contact information.
Additional Information Group Memberships
underpaid, underappreciated, partially crazy.
middle of nowhere Nebraska
Appliance Tech. for 26 years
ThatGuy is not a member of any public groups

All times are GMT -7. The time now is 10:37 PM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17