 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Taylor8 |
| View Profile: Taylor8 | |||||
|
|||||
New element, thermostats good, No heatI finally found the problem. The black wire coming off the motor had arced. The wire burnt into inside the wire harness. I pulled out the wire, it was green with corrosion. I guess with time the... |
|
New element, thermostats good, No heat Not a bit thanks for helping. The motor is running, everything except the element. I have double checked the thermostats. I checked the 240 volts at the wall receptacle. I will check inside the dryer... |
|
New element, thermostats good, No heat Thank you. I followed your directions. Checked the connections that you said on the timer, all of them are closed. The selector switch has closed connections and the motor switch has a closed... |
|
New element, thermostats good, No heat Thanks simon. Yes the wires were taken off of the thermostats before checking continuity. There is 240VAC at the dryer. We checked the timer. We unplugged the two black wires that has each end... |
|
Can't get drum back in Did you take the screws out of the drum? or can you just not slide it back inside the joint? I found this out the hard way. Dont take the screws out of the back of the drum. It just pulls out and... |
|
New element, thermostats good, No heat - New element, thermostats good, No heat Electric dryer DWLR473ETOWW GE. The element looked like it was burnt into so I replaced that. No heat. I then went and checked all of the thermostats with an Ohm meter, no resistance. I don't know... |
| Forum Info | Contact Info | |
|
Join Date: 01-13-2013
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
