 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » supertramp |
| View Profile: supertramp | |||||
|
|||||
fixed the ignitor, but still no gas - all fixedwell it's all fixed. by way of closing this thread, the problem was with the thermal fuse. it was fairly easy to put back together, and all-in-all a simple job. total cost was $20 for the fuse and... |
|
Which wire to which terminal on the flame sensor? - all fixed Well I put it back together with the blue wire on the top terminal and the white one on the bottom, and it worked just fine. Thanks to all the experts on this forum. |
|
Which wire to which terminal on the flame sensor? - Which wire to which terminal on the flame sensor? Oops - I removed the flame sensor from the dryer but forgot to track which terminal gets the blue wire and which gets the white one. Could someone tell me if I promise never to make such a stupid... |
|
fixed the ignitor, but still no gas - Which wire to which terminal on the flame sensor? Hi Tom, Thanks for your time and advice. Here's what I did: I disconnected the wires (but did not remove the fuse from the dryer) and used the digital multimeter on the two terminals. I cycled... |
|
fixed the ignitor, but still no gas - fixed the ignitor, but still no gas Dryer is Whirlpool Gas Ultimate Care II, Model # above. No heat, so I stripped the whole thing down. Electric motor works fine, but no flame. The ignitor was not working and when I pulled it out... |
| Forum Info | Contact Info | |
|
Join Date: 01-12-2009
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
