| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Rhatcher |
| View Profile: Rhatcher | |||||
|
|||||
|
It was the gas valve. A word of caution, the three screws that hold the gas valve in place are very tight, not exactly self threading but definitely a friction fit. while trying install the screws in... |
|
Thanks Gene, Ill do that today. I was able to run the heating assembly independently last night and got the same results. That isolates it to the Gas Valve Assembly, ignitor and flames sensor. The... |
|
Thanks Gene, I remembered that my old dryer had a dchematic tped inside the lower panel and sure enough I found the schematic for the new dryer folded up real small and tie-wrapped in a corner. |
|
As I said in the OP after re-reading allot of posts and looking at information on the web i still think it should be the coils although I replaced them. how often are they bad out of the box? I... |
|
Gene, where there any additional pages that had the electrical schematic? I am troubleshooting a problem... |
|
Originally posted asking for help with removing front cover. http://forum.appliancepartspros.com/dryer-repair/515400-remove-bosch-dryer-front-panel.html#post794551 Now I’m troubleshooting the actual... |
|
That's great Gene. I will go through those, with a fine toothed comb, tonight! |
| Forum Info | Contact Info | |
|
Join Date: 01-13-2013
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|