Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » PNWDrew

View Profile: PNWDrew
PNWDrew is on a distinguished road
PNWDrew PNWDrew is offline
Senior Member
 
Last Activity: 04-12-2017 08:50 PM 

DIY troubleshooting, now stumped
You have a fun one! Only runs during wrinkle prevent...

If I was called to your house I'd get you a timer with fingers crossed. I still say ignore the moisture sensor board, as I rarely see them...
Fridge and freezer not cooling
If you have a multimeter you need to determine if the PCB is trying to continuously power the compressor while it cycles on the overload or if the PCB is failing to close the relay to power the...
Refrigerator not cooling enough
The noise you hear is the compressore trying to start as you say. I'd say one of 2 things is happening.
#1 - The Adaptive Defrost Control ...
Frigidaire ADC board
It's a pretty deep hole. Your nut driver may be too fat to fit in there, or the head may be rusted, or it may have been replaced by another screw.
Can you use a mirror and a flashlight to see it?...
Freezer temp seems to be controlled by frig.
Your temp control in the fresh food side should control the operation of the whole unit. The freezer knob just controls how much freezer air is diverted to keep the FF side cool. In operation this...
Refrigerator on generator
You ask an interesting question.

I'm going to hope your meter is incorrect as 19.5A is a huge draw. If you are in the US it would be be unusual if any 120 circuit in your house was above 20A, which...
Kenmore 90 series plus not spinning
Your description does sound like a clutch problem, if not physically bad than at least oily from the gearcase.

Quick but potentially dangerous test: when empty put it in spin and depress the lid...
Forum Info Contact Info
Join Date: 02-02-2017
Posts
Total Posts: 130 (1.50 posts per day)
Last Post:
Kenmore 90 series plus not spinning
04-09-2017 03:39 PM
Find all posts by PNWDrew
Find all threads started by PNWDrew
Referrals: 0
PNWDrew has no contact information.
Additional Information Group Memberships
Location:
WA
Occupation:
10+ yrs appliance service tech
PNWDrew is not a member of any public groups


All times are GMT -7. The time now is 10:13 AM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17