 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » phillip melton |
| View Profile: phillip melton | |||||
|
|||||
heats for 10 mins..shuts off - heats for 10 mins..shuts offreplaced roller..cleaned gas dryer thoroughly..started up..only runs 10 mins .I tried it in all modes..reg perm press..air. The only thing I did was I forgot how the wires to the door switch went... |
|
control board display on - heats for 10 mins..shuts off thank u gene for prompt reply...I pulled up the part number and it says a qualified tech might be needed...due to some model changes..should I try this myself?? I do not fear any plumbing job,(i can... |
|
control board display on - control board display on display does not flash..does not show error code...all numbers display...and stay lit. coincidently,my furnace went out same day.. repairman replaced control board. left power off full day..did... |
|
Washer stops whene it should pump out water - control board display on are you giving it enough time to cycle? (my wife has an amana, and ittakes about 5 min to go to rinse/pump..) |
|
no heat - no heat I purchased an admiral portable air conditioner/with a heater mode,which has never worked. The product use and care manual reads like it was printed overseas. I have called the 800 number,and... |
| Forum Info | Contact Info | |||||
|
Join Date: 10-01-2007
Referrals: 0
|
|
|||||
| Additional Information | Group Memberships | |||||
|
|
