Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » patmac

View Profile: patmac
patmac is on a distinguished road
patmac patmac is offline
Junior Member
 
Last Activity: 05-28-2015 01:14 PM 

Touch Panel or Control Board Bad? - Touch Panel or Control Board Bad?
Error message states "touch panel shorted"...
I've removed and re-seated the ribbon cable going from the control board to the touch panel, re-assembled everything, and it works for a while ( a day ),...
Where to get wiring schematic - Touch Panel or Control Board Bad?
This is a fairly old post so you may have solved the issue by now but....while working on my GE Microwave, I found the schematics behind the touch panel assembly...
Intermittent heating problem with gas dryer - Touch Panel or Control Board Bad?
The following link is for my thread with a similar problem. These folks here are mad busy, so I pushed through it myself.
...
RCA Dryer Heat Does Not Stay On - Touch Panel or Control Board Bad?
Figured it out.
Checked continuity on the high and low thermostats and the cycling thermostat, all good. Also good was the flame sensor and ignitor.
The gas solenoid resistance values were good, but...
RCA Dryer Heat Does Not Stay On - RCA Dryer Heat Does Not Stay On
Hi,
I've been here before for help with the same dryer.....got 5 more years out of it with help from this forum.
Now, the dryer heats up, but then then heat goes off after a while.
I opened it...
Kenmore Fridge - Fridge & Freezer Not Cold - Kenmore Fridge - Fridge & Freezer Not Cold
Hi,
A few days ago I noticed the fridge wasn't really cold when I opened it.
Yesterday, I noticed the same thing in the freezer.
I pulled the fridge out, removed the back panels and vacuumed...
Bottom Freezer Door Removal - Bottom Freezer Door Removal
Hi,
Before we get too far, my model number doesn't seem to come up in here. My post is for help with installing a new bottom freezer door gasket, which I purchased here. The last time I replaced it,...
Forum Info Contact Info
Join Date: 10-13-2009
Posts
Total Posts: 11 (0.01 posts per day)
Last Post:
Bottom Freezer Door Removal
09-15-2010 06:30 AM
Find all posts by patmac
Find all threads started by patmac
Referrals: 0
patmac has no contact information.
Additional Information Group Memberships
N/A
patmac is not a member of any public groups


All times are GMT -7. The time now is 10:37 PM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17