| Register | FAQ's | New Posts | Today's Posts | Extras |
| » NeptuneHelp |
| View Profile: NeptuneHelp | |||||
|
|||||
|
I would also check to make sure it is not over filling machine. Normally, the water level is so low that it should not even come out the door. The water level detector could be starting to fail. See... |
|
It sounds like the machine control in the top console has an issue. I always recommend to my customers to invest in a decent surge protector for any digital washing machine to help protect it against... |
|
I would check the water inlet screens for debris. Shut the water supply off, remove the hoses, use a flashlight and look up into the water inlets on rear of machine, remove any buildup with tweezers... |
|
Hi, If the machine was sounding like a jet plane taking off when in high speed spin cycle then the bearings need replaced. It is possible the spinner support or spider is loose or broken. See... |
|
The Whirlpool Duet Sport bearings and 8540091 Seal are at Duet Bearing (http://www.duetbearing.com). The replacement 8540091 seal works on the following Duet Sport models: CHW9900VQ0... |
|
I would consider repairing the Neptune. I would first determine how much damage there is to the balance ring, door panel, etc. If minimal, you can replace the bearings and seal for about $80 if... |
|
If the Neptune shuts off when filling it sounds like your water inlet screens are clogged. I would unplug machine, turn off water supply, remove hoses, look up into the water inlets and check the... |
| Forum Info | Contact Info | |
|
Join Date: 06-21-2009
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|