 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » neptune help |
| View Profile: neptune help | |||||
|
|||||
Maytag Neptune Makes Clicking Sound During Wash CycleCheck out NEPTUNE BEARING (http://www.neptunebearing.com) for bearings and a special tool kit created for the Neptune bearing job. The tool rental also includes the use of a DVD that shows step by... |
|
Maytag wont spin - Maytag Neptune MAH3000 won't spin after wax motor replaced Hello, If the door lock light comes on but won't spin then it is usually a mechanical issue in the door latch assembly. If wax motor energizes but still no spin: i.e door lock light now comes on... |
|
Maytag Neptune won't drain below tub - Maytag Neptune MAH3000 won't spin after wax motor replaced Hello, The sloshing sound you hear when rotating the inner tub is the balance ring which contains liquid and is an important component of the Neptune's balancing system. Hear the new neptune... |
|
Maytag washer not spinning - Maytag Neptune MAH3000 won't spin after wax motor replaced You have to replace the faulty 12002535 wax motor or the Q6 and R11 will fail again. See MAYTAG NEPTUNE WASHER R11 Q6 REPAIR KIT + 12002535 WAX MOTOR (http://www.neptunehelpsong.com) for a cute song... |
|
Worn out belt or something else? - Maytag Neptune MAH3000 won't spin after wax motor replaced The new neptune 12001788 belts are hard to get back on because they are very tight and you have to be careful not to pinch your fingers when you slowly turn the pulley. |
|
Maytag Neptune MAH5500 BWW washer - Maytag Neptune MAH3000 won't spin after wax motor replaced Hello, it could be the seal starting to go out. Once that happens the bearings will go, too. You can change the bearings and seal kit and save lots of money. See NEPTUNE BEARING... |
|
replacing motor control assembly - Maytag Neptune MAH3000 won't spin after wax motor replaced The wire harness on the 12002039 motor conversion kit is usually wrapped around the motor when it arrives in the box and it plugs into the edge of the motor control control board. Did you perform the... |
| Forum Info | Contact Info | ||||
|
Join Date: 01-27-2008
Referrals: 0
|
|
||||
| Additional Information | Group Memberships | ||||
|
|
