 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » moody9207 |
| View Profile: moody9207 | |||||
|
|||||
Squealing NoiseHi Simon, after repeated attempts to properly seat the drum with the ballhitch attached, I decided to remove it and check some measurements and I think now that the drum / ballhitch is seating okay,... |
|
Squealing Noise Hi, I greased up the sleeve, installed the ballhitch/drum together, but it won't set in place. I think I should have installed the ballhitch by itself first to make sure it's correctly in place, then... |
|
Squealing Noise one more question about the amount of grease to apply to the new sleeve for the ballhitch - just a thin coating, a small dab in the middle to get pushed around on the ballhitch or more? |
|
Squealing Noise Thanks, Simon - you can see that I had already disconnected the ballhitch from the drum, so if I understand correctly, I need to reattach the drum to the ballhitch, then pull up on the drum and pull... |
|
Squealing Noise Hi Simon, the dryer again doesn't produce any heat and I've confirmed that the heating element has no conductivity, so that is the likely problem. I also checked the idler pulley and it seems to spin... |
|
Maytag Dryer doesn't work Hi all, the problem was the control board and it had a burn spot on it. I enclose some photos with this post. The closeup is for the top right triangle area, the burn spot is evident. I didn't think... |
|
Maytag Dryer doesn't work More information for your review and insight. I pulled the dryer thermister and checked it for continuity and it tested good. I opened the door and pressed in the door switch by hand to see if the... |
| Forum Info | Contact Info | |
|
Join Date: 04-22-2012
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
