 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Markram |
| View Profile: Markram | |||||
|
|||||
the timer sticks and will not finish cycle when it gets to rinse it fills but stopsIt is probably your timer if you can get it to finish a cycle by turning the timer or whatever you are doing with it. These units sometimes have issues with the wiring harness on the inside top... |
|
Whirlpool washer With leaks, one cannot diagnose easily without being there. If you cannot pinpoint where leak is coming from, then it would all be guessing on my end. It is not a common issue that I run into... |
|
Maytag Top load has weak water pressure on Rinse First check the cold water inlet valve screen located at the machine end of fill hose, it may be clogged. If it is clogged, clean it out well and then see if that works. No need to replace the... |
|
kenmore washer won't drain all the way Yes, only 2 or 3 towels can cause an unbalanced load. You really need to figure out what is going on with machine. Initially you mentioned that it will not drain out. Now it seems that it will... |
|
Washer leaks long after cycle is complete Air vent is at top left rear of unit. There is no easy thing to tell you for a leak. You basically have to find where it is leaking and then go from there. There are too many places for a... |
|
Kenmore Elite HE3t F06 Error (checked continuity) You tried a different motor? I hope you didn't have to buy that new... Test the Motor Control Unit first according to the tech manual directions. I don't ever recommend throwing parts at an... |
|
Washer leaks long after cycle is complete There is an air vent on that side of unit, and excessive sudsing during a spin cycle (which happens to be end of cycle) will push out some of the suds and cause a small amount of water to leak out... |
| Forum Info | Contact Info | |
|
Join Date: 03-07-2012
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
