Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » markham

View Profile: markham
markham is on a distinguished road
markham markham is offline
Junior Member
 
Last Activity: 05-04-2009 03:52 PM 

GE Washer won't balance during spin - GE Washer won't balance during spin
I had this washer apart about a month ago to repair/replace the transmission.

Everything shifts, cycles and runs as it should. However, the machine now has a very tough time balancing loads...
GE Washer Roars During Spin Cycle - GE Washer won't balance during spin
Wanted to follow-up on this one...

The root of my problem was a bad tub seal which cost about $9 to replace. It was letting water drip slowly down the transmission shaft and on/in to the ball...
GE Washer Roars During Spin Cycle - GE Washer won't balance during spin
Okay...
The lower bearing on the transmission close to the pulley is toast.

I have the left-hand threaded nut off of the inner tub, it was a tough one!

The hub of the inner tub is soking up WD40...
GE Washer Roars During Spin Cycle - GE Washer won't balance during spin
There's nothing in the tub... I just ran a quick cycle with the front panel off so I could watch and listen better.
Everything is normal during the wash & drain cycles.
As soon as the whole...
GE Washer Roars During Spin Cycle - GE Washer Roars During Spin Cycle
My washer makes a really loud roaring sound during the spin cycle (especially during high speed spin). :eek:

To me it sounds like a bearing that is going/gone bad. In looking at the diagram...
GE Profile Control Board ??? - Main Power Board
I bought this range used/liquidated, so no warranty that I'm aware of... I think I will call GE and inquire anyway. The worst they can tell me is no!:rolleyes:

When I had the range out last...
GE Profile Control Board ??? - Try Model# JS998BH1BB in GE database
I found Model# JS998BH1BB in the GE database.
Don't know why the range ID tag has a 0 or O in between the B and H, but it does.

:confused: Anyone know if GE does cryptic stuff like this on...
Forum Info Contact Info
Join Date: 07-25-2007
Posts
Total Posts: 9 (0.01 posts per day)
Last Post:
GE Profile Control Board ???
08-20-2007 09:37 AM
Find all posts by markham
Find all threads started by markham
Referrals: 0
markham has no contact information.
Additional Information Group Memberships
N/A
markham is not a member of any public groups


All times are GMT -7. The time now is 01:58 PM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2010, Jelsoft Enterprises Ltd.
LinkBacks Enabled by vBSEO 3.0.0

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17