|
|
|
|
Won't spin high speed after bearing repair - Maytag Neptune Motor Conversion Kit
The washer was working fine (spinning out ect.) prior to the noise from the bearings. I noticed it (the noise) late one night and immediatly shut it off. We did not continue using the washer. Could...
|
Won't spin high speed after bearing repair - Maytag Neptune Motor Conversion Kit
Hi Rich,
We did as suggested to check the struts. Looked as though the one on the left (looking at the back of machine) was bad. We replaced the struts but the machine is still not spinning out in...
|
Won't spin high speed after bearing repair - Springs and struts look ok .
Hi guys. My husband removed the panels and everthing looks ok as far as springs and struts. Should we start looking at switches and such? Which one would be most likely the best place to start? Any...
|
|
|
Won't spin high speed after bearing repair - Springs and struts look ok .
I was hoping it was something easily enough to fix. We'll try that. Thank you for this and also the bearing repair info. It really helped.
|
All times are GMT -7. The time now is 10:52 AM.
The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc.
