 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » logangm |
| View Profile: logangm | |||||
|
|||||
My Kenmore Dryer will heat when turned on but will not startAlso you need to check your vents to make sure you have good airflow. |
|
My Kenmore Dryer will heat when turned on but will not start Yes you blew the thermal fuse again. You probably need an element. It sounds as if its shorted to the case. Easy to check use a continuity check with a Multimeter. If you get continuity from either... |
|
Kenmore Elite HE4t getting VERY hot No those switchs don't really go bad often. Go through the same process as the other guy. Remove vent to make sure its not that. Check the element for continuity to the heater box. And then I would... |
|
Kenmore Elite HE4t getting VERY hot Yes replace that element. It my not be touching at that moment or it may not be obvious. But you should NEVER get continuity to ground unless its broke. |
|
New timer, lid switch bypassed. Need help with diagnosis If motor isn't getting hot. It's probably a loose connection esp since it works after you take apart and put together. You are probably shaking something so that is gets a better connection. I would... |
|
My Kenmore Dryer will heat when turned on but will not start Its wrapped around the drum...on the front of the dryer in between the top and front panel roughly 4 inches from each edge is metal clip. Push in on it with a flathead or paint scraper and lift at... |
|
LG dryer not drying I would replace the thermistor. They often go out on these newer LG and are a pretty cheap part. Under 30 dollars |
| Forum Info | Contact Info | |
|
Join Date: 09-14-2012
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
