| Register | FAQ's | New Posts | Today's Posts | Extras |
| » killermrob83 |
| View Profile: killermrob83 | |||||
|
|||||
|
Got the problem corrected; just not sure if it will be long term. Took an indelible marker and put a mark on the bad ignitor, approximately 180 degrees from where it appeared that the spark was... |
|
Have a Kenmore gas range that was purchased in Oct '10. The ignitor went out on the front right burner. It is actually still working, but arcs through the side as if the ceramic is cracked. I thought... |
|
Our GE dishwasher doesn't always want to complete a full cycle. When it doesn't function properly, the timer seems to hang up at the beginning of the 'RINSE AND HOLD (PRESS OPTIONS RESET)' mark. I... |
|
Thank you, I have ordered a spark module (igniter) and that should take care of the problem. While searching for info I found a place in Windsor, Ontario that rebuilds clock timers for half the cost... |
|
Thank you so much with your diagnosis, but another problem has just occurred..............the auto ignition has stopped functioning for the stove top. Would I be fortunate enough for the same... |
|
Upon further investigation into the problem, I have discovered that the problem does not lie in the membrane switch. The only other parts that could be the problem are 7428P010-60 (relay board) or... |
|
1994 Magic Chef 6498VTA oven temp 175 degrees below setpoint as indicated by oven thermometer touchpad digitally indicates that temp is rising normally until desired setpoint is reached, then... |
| Forum Info | Contact Info | |
|
Join Date: 08-17-2009
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|