 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » jumptrout51 |
| View Profile: jumptrout51 | |||||
|
|||||
dryer stopsCheck rear drum support for excessive wear. A dragging drum will cause the motor to overheat and shut down. You may hear a scrapping noise at rear of dryer. |
|
Dishwasher not cleaning Remove approximately 8 screws from the cover below the spray arm and check for debris clogging the area below.Also check the impeller for excessive wear. Click on your model number in this thread for... |
|
Overfilling Washing Machine Move switch to reset then to small water level. Then put machine in the spin cycle for a full spin sequence. Then retry super level and see if water overflows. If so replace water level switch. P.S.... |
|
Actuator replacement It all replaces and accessess from the front. The black cover is attached by plastic clips. Most snap forward and then raise panel towards top of machine in a sliding motion. |
|
coil freeze up Check continuity on the heater leads. Pay attention to the wires on the leads. I have seen them get loose and come off. |
|
Loose Baffle Turn off breaker or unplug dryer.Remove 2 screws on bottom front side of the door panel.Remove front door. Remove 2 screws top right and left side of lid. Raise the lid on the dryer. Turn the drum by... |
| Forum Info | Contact Info | |
|
Join Date: 09-20-2007
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
