Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » juanrodman

View Profile: juanrodman
juanrodman is on a distinguished road
juanrodman juanrodman is offline
Junior Member
 
Last Activity: 05-26-2014 07:20 PM 

Fridairaire Gallery Leaking Water - Fridairaire Gallery Leaking Water
Update to my original post : Found a sheet of ice on the bottom of the freezer side with some water dripping from the back compartment. Removed the rear freezer panel and found the coils not overly...
Spin Noise and Vibration - Spin Noise and Vibration
When the washer hits the spin cycle with a heavy load, the tub often goes out of balance and hits the outer tub causing the washer to "walk". This can usually be helped by redistributing the clothes...
Cannot Separate the Upper Agitator (mover) from the Lower Agitator - Spin Noise and Vibration
I have this same washer (MAV6300AWW) and did get the lower and upper agitators apart. However I also found a 1 inch piece of broken plastic (cylindrical - sort of made up of concentric circular...
Dryer Heating Inconsistently - Dryer Heating Inconsistently
Dryer not consistently heating in "Timed Dry" mode and when it does the heat is low. When in that mode, there is a fairly loud clanking noise (not like the click when heat comes on) if the Timer...
Gas Range Burner Issues - Gas Range Burner Issues
Having problems with the two front burners on a four burner gas range. When turned on, the left front burners gets no gas (no odor and can't light with match) and no sign or sound of spark (probably...
Washer Won't Complete Cycle - Washer Won't Complete Cycle
Approximately 15 year old machine suddenly won't run through a full wash cycle. No matter which wash cycle is selected, it runs through the wash, drain and partial rinse and then STOPS. Thanks in...
Noisy Maytag Atlantis - Washer Won't Complete Cycle
I lifted the washer, turned it on spin and noticed some wobbling on the motor shaft. I guess it could be a bearing or a pulley issue, neither of which seem easy to confirm. I'm wondering if a fix...
Forum Info Contact Info
Join Date: 11-13-2007
Posts
Total Posts: 26 (0.01 posts per day)
Last Post:
Noisy Maytag Atlantis
02-01-2012 11:38 AM
Find all posts by juanrodman
Find all threads started by juanrodman
Referrals: 0
juanrodman has no contact information.
Additional Information Group Memberships
N/A
juanrodman is not a member of any public groups


All times are GMT -7. The time now is 02:07 AM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17