| Register | FAQ's | New Posts | Today's Posts | Extras |
| » jonzo |
| View Profile: jonzo | |||||
|
|||||
|
Hey all! I did find a wire to metal contact inside the heat pump outdoors..so i fixed that and all seems to be running fine...except a spark arced inside the heat pump that MIGHT have damaged... |
|
Have a Trane heat pump outside.....that is running...and not iced up at all..but no heat is being generated. Earlier today, I was tracing down an electrical short in the 24volt thermostat wiring in... |
|
HELP!!!! I've pulling me hair out!!!! Original prob was air handler lost 24 volt output. I replaced transformer with a slightly undersized one....40va instead of the spec'd 60va......and it ran for... |
|
A "knowledgeable" person told me it was ok to downsize my blown 25 year old Carrier air handler transformer from 60va to 40va, cos it was "probably oversized " to begin with in the original specs. It... |
|
Hey Joe! I switched the two relays..and both are working now! I've got a running motor AND heat! Hmmm...well...a couple days ago..when the prob first started with the START KNOB..after the duct tape... |
|
Thanks so much, Joe! The endcaps have two plastic legs that insert into the metal top..and then..as you said..have a spring clip on bottom...just back from the front edge...that seems to like being... |
|
Hello All! OK..have spent hours researching this online..but have gotten stuck trying to remove the endcaps on our Kenmore dryer. I must be a total numbskull...cos I've even watched videos where the... |
| Forum Info | Contact Info | |
|
Join Date: 09-30-2010
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|