Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » Joe / APP Team

View Profile: Joe / APP Team
Joe / APP Team is on a distinguished road
Joe / APP Team Joe / APP Team is offline
Senior Expert
Joe / APP Team's Avatar
Last Activity: Yesterday 07:58 AM 

Signature
Thanks for allowing AppliancePartsPros.com to assist you,

Joe M. APP TEAM



Find Appliance Parts at AppliancePartsPros.com - Largest inventory in the U.S. with 91% of all in-stock orders delivered within 2 business days. Thousands of photos and diagrams make it very easy to find the right part. Enter your appliance model here.

Microwave overheats and shuts off automatically
Yes, we decided to use that model number when researching for parts and locations, etc.

The part numbers for the thermostats are:

AP4564957
AP4564954

Once you access them, one thermostat will be...
Microwave overheats and shuts off automatically
Thomas, The thermostats you're interested in are located on the bottom of the microwave cabinet, behind the control panel inside the component cavity. You'll need to remove the control panel to...
Dryer shuts off after getting too hot
Geotactic, under the circumstances, new dryer, new breaker rigid vent, overheating and tripping the breaker, you'll need to check for a shorted or pinched wire to the heater element or an element...
Maytag Neptune front load 3E error during spin
AKuhns, Ok , your meter has 200 ohms as the lowest resistance setting, Place the meter at 200 and recheck the CN9 pin 1 to 2, pin 1 to 3 and pin 2 to 3 you should have a resistance reading of 3 ohms...
Maytag Neptune front load 3E error during spin
AKuhns, You can set the multi meter resistance setting wrong, and you will receive an "open" circuit reading if you do. You want to use the lowest setting possible, or the closest setting without...
Maytag washer Error Code F51
Hardychas, Great, glad to hear you repaired your washer. Apparently, you do have the talent for this sort of thing. Great Job and Good Luck
Whirlpool duet leaking from detergent dispenser
Dlrepp, Under certain installations (basements garages etc.) that can happen. As long as the washer cabinet is level, in both directions you're OK.

If the washer is higher in the back, it could...
Forum Info Contact Info
Join Date: 07-14-2010
Posts
Total Posts: 5,026 (3.02 posts per day)
Last Post:
Whirlpool duet leaking from detergent dispenser
01-02-2015 08:26 AM
Find all posts by Joe / APP Team
Find all threads started by Joe / APP Team
Referrals: 0
Additional Information Group Memberships
N/A
Joe / APP Team is not a member of any public groups


All times are GMT -7. The time now is 09:05 AM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17