Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » jimctec

View Profile: jimctec
jimctec is on a distinguished road
jimctec jimctec is offline
Junior Member
Last Activity: 11-01-2017 05:58 PM 

See if you can immediately restart the dryer after it shuts off. If it will not try to start then I suspect your motor might be overheating and has to cool down and reset before it will start again....
washier repair
Is the washer running the pump to pump the water out or is the water draining out on its own without the pump? Perhaps you need to elevate the drain hose.
Frigadaire top-loader agitates, but does not spin.
Possibly the belt issue, could be in trans. Remove the front of the machine so you can observe running in spin mode. If the trans pulley is turning problem is likely in trans. If motor is running but...
Kenmore 800 Washer no spin on delicate cycle spins fine on others
Could well be timer, or if there is a slow speed on the motor used only for delicate cycle it could be a problem in that.
Whirlpool belt drive washer won't spin.
Have you located the tech sheet? It gives info on automatic and manual test modes and how to read error codes. The shifter you have watched move several times also contains a sensor telling the MCU...
No motor action
Second new control board made no difference. Further testing led to replacement of the Hall sensor, which seems to have cured the problem..
No motor action
Negative on an inline fuse; further testing has led us to believe the new control board is defective. Awaiting a replacement...
Forum Info Contact Info
Join Date: 06-06-2016
Total Posts: 18 (0.03 posts per day)
Last Post:
No motor action
03-16-2017 10:11 AM
Find all posts by jimctec
Find all threads started by jimctec
Referrals: 0
jimctec has no contact information.
Additional Information Group Memberships
jimctec is not a member of any public groups

All times are GMT -7. The time now is 08:52 PM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17