Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > View Profile » jaywalker1981

View Profile: jaywalker1981
jaywalker1981 is on a distinguished road
jaywalker1981 jaywalker1981 is offline
Junior Member
 
Last Activity: 10-31-2013 08:42 AM 

do drain hose check valve go bad - do drain hose check valve go bad
I took the dishwasher out to replace the hot water hose to the washer. I was in two minds whether I should replace the drain as well. The existing drain hose(AP3178188) has the check valve in its...
Hvac Blower motor problem - Hvac Blower motor problem
My hvac blower started making a noise that is progressively getting worse. I removed the motor and ran it without the load(blower). No noise.

Than I add the blower cage to it and that's when I...
replace torsion spring in micro door - Hvac Blower motor problem
At this time I think both of us agree that the problem is with the part. Earlier you said I could have received a part from the old batch. How do I verify if its from the old batch or not?

I have...
replace torsion spring in micro door - micro door
Hi Ted,

Unfortunately I have tried these steps before and used a plastic tie in the middle where they cross but that did not make a difference.

I appreciate your taking the time to respond. I am...
replace torsion spring in micro door - micro door problem
Hi Ted,

Yes I have the parts you listed. Infact they are the same parts that I have been using. I got a new LH spring because the door kept falling and installed new springs for both LH and RH side....
replace torsion spring in micro door - micro door off
Hi Gene,

First of all I really appreciate you taking the time to go over my emails. As much as my patience is wearing low I want to take care of this myself(really low on budget :( ).

Here are the...
replace torsion spring in micro door - video of the door with both springs replaced
Hi,

Replaced both springs on the door. However there is hardly any difference between when the RH spring was busted and now(even though I have replaced both springs). Without attaching the SS door I...
Forum Info Contact Info
Join Date: 05-14-2012
Posts
Total Posts: 10 (0.01 posts per day)
Last Post:
replace torsion spring in micro door
06-04-2012 07:24 PM
Find all posts by jaywalker1981
Find all threads started by jaywalker1981
Referrals: 0
jaywalker1981 has no contact information.
Additional Information Group Memberships
N/A
jaywalker1981 is not a member of any public groups


All times are GMT -7. The time now is 07:54 AM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17