 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » herman |
| View Profile: herman | |||||
|
|||||
agitator problem - agitator problemhow do i remove agitator. i removed the softner part now i see a clear plastic shield, how do i remove this? are thier plastic dogs under this? it does not seem to be agitating right. thank you dave:( |
|
inlet valve - inlet valve how do i remove the dryer from the washer, so i can replace the inlet valve. thank you dave:) |
|
not cooling - not cooling i think it's a defrost problem. i know where the board is but not the defrost thermostat. how do i check these parts.thank you dave.:) |
|
won't cycle. comes on for about 30 secounds venting clear - won't cycle. comes on for about 30 secounds venting clear i'v checked venting also thermostat on side of heater. lint screen clean.if i open the the little round door at rear it comes on but goes out in about 30 secounds .if i open and close the lint door... |
|
dead - dead checked all of door sw. fuses, one cermic the other on the top. not sure where else to go . is there a way to check the keypad/board thank you so much... |
|
lost all freezer food - lost all freezer food lost all food comp ok all fans ok how do i check the heaters with the timer. when i removed the back it was all iced up. i'm just not familiar this new part. thank you... |
| Forum Info | Contact Info | |
|
Join Date: 07-20-2007
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
