 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Gilbert K |
| View Profile: Gilbert K | |||||
|
|||||
Blowing thermal fuses - Blowing termal follow upGene: I had only tested the heater with power disconnected, either uninstalled or pulling the dwasher out, disconnecting the wires and putting the leads there. One digital meter reading varied... |
|
Blowing thermal fuses - STILL Blowing fuses I replaced the heating element and circuit board again and blew the fuse at the 48 minute mark, about the time the heating light should come on. I opened the cover and the yellow wires were very... |
|
Blowing thermal fuses - Thermistor Simon I tried to us my ohm meter on the P2-2 (yellow) and P7 (white) wires but the reading did not change. Does this mean that thermistor needs to be replaced? Where is the thermistor in the... |
|
Blowing thermal fuses - Blowing thermal fuses Simon Yes I did replaced both the heating element and control board. I noticed that with the new board, the machine starts the cycle after about 3 sec it stops and continues to at water. When... |
|
Blowing thermal fuses - Blowing termal follow up Simon I have the stainless tub and two service appointments to replace the fuse with the new harness. Since I have replaced the fuse setup several times before I found the thermal fuse and now I... |
|
Blowing thermal fuses - Blowing thermal fuses Our Kitchen Aid dishwasher was blowing thermal fuses and when I checked the heater element and I had ohm readings of 57 to 95. The wiring diagram indicated a reading of 35. I order a replacement,... |
|
Kitchen Aid Thermal fuse problem - Kitchen Aid Thermal fuse problem Our Kitchen Aid dishwasher continually blowing thermal fuses. I stopped the washer in mid cycle and tested the water temp. It is at the same temp as out of our water heater. Could the heating... |
| Forum Info | Contact Info | |
|
Join Date: 07-06-2011
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|
