| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Gene |
| View Profile: Gene | |||||
|
|||||
| Signature |
| Professional appliance repair in Orange County, California. |
|
The motor runs without any load. The start switch should interrupt power to the motor start windings as soon as the motor got to a proper speed. If the switch shorted then it provides power to the... |
|
Yes, it can. But I would not replace any parts without testing them for continuity. Looks like you already spend much more $$$ than it's needed. Can you post which parts you already replaced by using... |
|
Normal temperature for the freezer is about 0°F and for refrigerator between 36°F to 40°F depends on level. The most accurate thermometer is a mercury. Gene. |
|
The first thing I would do is check the lid switch (#11 on the diagram (http://www.appliancepartspros.com/partsearch/model.aspx?model_id=261664&diagram_id=99801)). - The lid switch AP3100003 Here... |
|
Carefully assemble it back. Make sure the drum is in place and the belt goes properly around the motor shaft and idler pulley. The belt diagram bellow would help... |
|
Most likely the problem is a bad control board aka a clock/timer. The model number you posted does not come up. Verify and repost it. Gene. |
| Forum Info | Contact Info | |||||
|
Join Date: 07-19-2007
Referrals: 21
|
|
|||||
| Additional Information | Group Memberships | |||||
|
|