| Register | FAQ's | New Posts | Today's Posts | Extras |
| » gciccol |
| View Profile: gciccol | |||||
|
|||||
|
OK thanks for getting back to me. Just wanted to make sure there wasn't something else I should be checking. Don't feel like dealing with the mold inside there again. Thanks for all the wisdom. ... |
|
I removed the old piston and nut. The rubber plug was half gone. I replaced it with a new one and ran the dishwasher. I cleaned and checked all the hoses and the line into the garbage disposal. I... |
|
Your recommended fix was a success. The only challange I had was getting the old push-on nut off the shaft. I ended up just cutting it with snip's. Your suggestion to take a picture first was also... |
|
Thanks for the prompt response and the suggestion. I appreciate you're supplying the part number too. I'll order the parts and report back on the results. Take care.:) |
|
Thanks for the prompt response and the suggestion. I appreciate you're supplying the part number too. I'll check it out and report back. Take care.:) |
|
I have a leak on the back side of the plastic piece of the pump drain valve arm that hold the bar to make the valve go up and down when the solenoid engages. It only leaks when the arm is in the... |
|
After the dishwasher finishes its cycle there is always some standing water left in the tub. It's by the sump drain, only about a 1/4 inch. I have removed all the hoses and checked them for... |
| Forum Info | Contact Info | |
|
Join Date: 04-17-2011
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|