| Register | FAQ's | New Posts | Today's Posts | Extras |
| » gblotter |
| View Profile: gblotter | |||||
|
|||||
|
Problem fixed - see solution below. Apparently the washer will not enter the spin cycle unless/until the water has drained from the drum. I removed the lower panel to check the drain line and the... |
|
My GE front-loader washer advances through the cycles, but will not drain or spin at the end. During the spin cycle, I sometimes see it agitating as it does during the wash cycle. I have read other... |
|
My GE DSXH43GV0WW dryer is leaving brown marks on clothes. Sort of looks like rust marks, but I don't think it is rust because it isn't a stubborn stain like rust - washes right out. After examining... |
|
I was vexed with this same problem of leaks at the right door hinge. By experimenting with the setting of the rinse-aid dispenser, I discovered that I could get the leaking to stop. The rinse-aid... |
|
The rinse-aid dispenser is defective (bad design). It is a potentially dangerous problem that could result in a fire. There is a Maytag recall for this issue. See... |
|
The parts diagram actually shows two thermostats ... Part Number AP2804281 is Tstat near the control panel and costs $44.18 Part Number AP2804285 is Tstat near the heater and costs $17.38 The... |
|
Less than a year after replacing the selector switch, the problem has returned. The dishwasher hangs during wash and again during rinse - with both Regular mode and Scrub mode. Not intermittent -... |
| Forum Info | Contact Info | |
|
Join Date: 05-12-2011
Referrals: 0
|
|
|
| Additional Information | Group Memberships | |
|
N/A
|
|